Spares
Friction Strip
The friction strip which fits all our machines and is a common point of wear.
Complete Electrical Loom
A complete electrical loom replacement circuit which will work on all Acorn traps.
4 Hole Friction Strip
The friction strip which fits our RapidFire 90 machines and is a common point of wear.
Iris Spring
Supports for clays on RapidFire 90, AutoClay 65/90
Microswitch
Arm limit switch on the AutoClay 320 and Rapidfire 90
AutoClay Reed Switch
Launch Arm (Silhouette)
The Launch Arm for older Silhouette ranges. Friction strips available seperately.
Launch Arm (AC 300 series)
The launch arm for the Autoclay 300 series. Please note that this part should only need replacing if it is damaged or bent, friction strips are available alone.
Launch Arm (AC65/90)
The main launch arm for AutoClay 65 and AutoClay 90 models. Please note that this is the part shown only.
Main Spring (Normal)
The main spring, very rare to need replacing. We also have different tension rated springs according to your needs.
Red Spring (Max Power)
The Legendary Red Spring!
High powered spring achieves a distance of 70 to 120+ metres
Black Spring
The main spring, very rare to need replacing. We also have different tension rated springs according to your needs.
A softer spring achieves a distance of 40 to 60 metres
Arm/Iris Cam
A contact point which is used on several models to actuate the iris during the loading cycle.
Pinch-Wheel Set (AutoClay 300 series)
Pinch Wheels are suitable for all Acorn carousel traps. These hold the upper clays in place to allow a single clay to drop onto the launch plate. The rubber rings are also available seperately.
Pinch Wheel Set (Rubber Rings Only)
Spare part for the pinch wheels which retain the upper clays during cycling on all AutoClay 300 models and later. Rings only. For the complete set with the wheels please see here.
Clay Retaining Plunger
RapidFire Brass retaining plunger fitted with a RED polyurethane hard wearing tip supplied with a spring and M6 Nyloc nut.
Used on all Acorn single stack models. AutoClay 65, 90 Silhouette and the early AutoClay.
Note;- The Brass Diameter may vary on some models.
Crocodile Clips
Simple Spade connecting Crocodile clips to attach the traps to a 12V leisure battery.
Main AutoClay 300 Motor
The main motor for the AutoClay 300 range.
Clutch & Seals
The clutch for our AutoClay series. Do not allow oil or grease into the section of shaft where the clutch grips.
Base Control Box
Multi use Control Box - Operates Oscillating Base, Quad Trailer Moving Base, Duplex Base and I-Bar Turner Base. Can also house any of the Acorn Radio Release Systems.
Quick Release Battery Terminals
Quick release batteries termals suitable to connect the AutoClay 320 and modular upgrades to a 12V leisure battery
Main Nylon Motor Gear
The main gear of the motor in our AutoClay ranges. This part is only known to fail due to misuse such as attempting to manually push the arm around causing it to impact the crank which will damage this component.
Carousel Pawl (AutoClay 300 Series)
This spring-loaded part is mounted on the swinging arm which cycles the carousel.
Spring Pivot
Spring pivot for the crank, onto which the main spring is hooked.
Arm Brush (AutoClay 300 Series)
The brush from the AutoClay 300 series launch arms which helps to keep the launch plate free from dust and debris during use.
Silhouette Iris Spring
50mm Tow Ball With Fixings
This standard 50mm tow ball fits on the Acorn Quad trailers, to enable the clay pigeon traps to be daisy-chained together, for easy movement on and off the shooting range.